Laparoscopic surgery offers distinct advantages to patients over open surgery such as shorter hospitalization, reduced postoperative pain, and better cosmetic results [21, 29, 31]. On the other hand, laparoscopic surgery is technically and physically demanding for the surgeon due to limitations in manipulation and visualization as well as physical discomfort [2, 4, 5, 10, 14, 16, 2325].

Robot-assisted surgical systems were developed to overcome many of the surgical disadvantages associated with laparoscopic surgery. Manipulation of the instruments is improved by increased range of motion for the instruments, correction of the inverted instrument response, and elimination of human tremors [1, 8, 20, 27]. Furthermore, vision of the operative field is improved by conversion of a two dimensional (2D) image to a 3D view. Additional advantages are a completely stable image and personal camera control. The physical discomfort of laparoscopic instrument handling is potentially reduced by restoration of the eye–hand-target working axis and physical support of the console [3, 18, 24, 26]. These advantages may reduce both the physical and mental workload, thus possibly improving both surgical performance and work satisfaction.

This experiment aimed to assess whether robot-assisted surgery benefits the surgeon by reducing mental and physical discomfort in comparison with standard laparoscopy. Additionally, task performance was evaluated to assess whether robot assistance can benefit surgical procedures [22].

Methods

In this study, 16 medical students (8 women and 8 men) each performed three tasks. These tasks were executed in a pelvic trainer in random order using both standard laparoscopic instruments (standard group) and the da Vinci robot-assisted surgical system (Intuitive Surgical, Sunnyvale, CA, USA) (robot-assisted group).

The participants were instructed in the tasks and techniques. To become familiar with the setup of the exercise, both the standard group and the robot-assisted group were allowed to practice each task for 2.5 min. All the tasks were executed for 5 min with the objective to achieve as many repetitions as possible. The participants had a 15-min break after finishing all three tasks, during which they were asked to complete the questionnaires. After the break, the participant performed all three tasks again, but now in the other group. The tasks were rope passing, needle capping and bead dropping. All tasks are described here below. At the end of this second session, the participants completed the questionnaires again. To encourage maximal performance, the most accomplished participant was given a bonus.

In the standard laparoscopic group, table height was adjusted to the individual’s preference. A horizontal instrument angulation less than 45° and a vertical angulation less than 15° [4] were always preserved. The monitor trolley was placed in line with the camera at a distance of 1.5 m from the pelvic trainer. The participants performed all the tasks using two dissection forcipes (B. Braun, Tuttlingen, Germany).

The robot-assisted group worked at the console, from which they controlled a three-armed da Vinci robot. Before onset of the tasks, each participant adjusted the console to his or her personal preference with regard to height of the chair, display clarity, optimal stereoscopic view, and comfortable armrest position. Both groups performed the same three tasks, and both groups performed all tasks with the same triangulation in the port placement setup.

Surgical tasks [11]

The following surgical tasks were performed.

Rope passing

A 25-cm-long rope (diameter, 0.3 cm) was passed as many times as possible. The rope was grasped alternately with the left and right instruments at the 11 marked grasping points. During this exercise, the participants were instructed to keep the rope above the floor of the training box.

Needle capping

A needle and a cap were grasped and lifted, after which the needle was capped repeatedly above the floor of the training box.

Bead dropping

Every participant was asked to pick up a plastic bead from a starting position, transfer it crosswise, and drop it into a receptacle. After the bead was dropped into the receptacle, it had to be picked up and transferred to another receptacle using the contralateral laparoscopic instrument.

Physiologic measurements of mental discomfort

An ambulatory monitoring system was used for registration of physical parameters. It could be worn beneath clothing, allowing the subject complete freedom of movement [12, 28, 32]. Three physiologic stress parameters were recorded with this device.

The first parameter was the mean square of successive differences between consecutive heartbeats (MSSD). This parameter reflects the beat-to-beat variability of the heart rate and is tightly linked to respiratory sinus arrhythmia (RSA). Changes in RSA can display changes in vagal activity [6]. If vagal activity decreases RSA, MSSD also will be reduced because fewer oscillatory changes in heart rate occur. An increase in stress will therefore lead to a decrease in MSSD. In conclusion, high MSSD values reflect low stress levels.

The second parameter recorded was the preejection period (PEP: time of isovolumetric contraction). The PEP is the interval between the onset of ventricular depolarization and the opening of the semilunar valves [19]. Changes in PEP correspond to changes in ß-adrenergic inotropic drive to the left ventricle. This correlation was shown by laboratory studies in which ß-adrenergic tone was manipulated by epinephrine infusion [15, 30], adrenoceptor blockade [13], exercise [14, 17], and emotional stress [7, 18].

The third parameter was the average heart rate (HRA) of the participants recorded by the ambulatory monitoring system.

All three parameters (MSSD, PEP, HRA) were constantly recorded during both the laparoscopic tasks and the robot-assisted tasks. The data were automatically divided by the ambulatory monitoring system device into 30-s periods. The average of these 30-s recordings was compared with a paired sample t-test using SPSS software, version 13.0 for Windows (SPSS Inc., Chicago, IL, USA).

Questionnaires

The participants completed two questionnaires. To score the level of stress, all the participants completed the Subjective Mental Effort Questionnaire (SMEQ) and the Local Experienced Discomfort (LED) scale. The SMEQ is a cognitive workload questionnaire with a scale of 0 to 150 points (Appendix 1). It is designed so that individuals can rate the amount of effort invested during a task. Nine scale markers with verbal statements ranging from “no effort at all” to “exceptional amount of effort” are displayed in the SMEQ diagram. The choice of statements and their scale locations are empirically derived. The SMEQ, used as a tool in various laboratory and field studies, is categorized as a cognitive test [33].

The LED allowed participants to express their physical discomfort during performance of all the tasks [9]. On a scale of 0 to 10 points, the participants were asked to identify their physical discomfort at several locations of the upper body (Appendix 2). Statistical analysis of both questionnaires was performed using a Mann–Whitney U test.

Task performance

All the procedures were recorded with a super-VHS recorder. Using these recordings, failures and successes of executed repetitions were applied to compare task performance between the two groups. The judgment for success or failure of a given task was based on consensus of the researchers.

Results

Physiologic measurements

Table 1 presents the physiologic measurements. The mean MSSD in the robot-assisted group was 31.7 ms. This was significantly higher than in the standard laparoscopic group, which had a value of 22.3 ms (t = −4.0; p = 0.01).

Table 1 Physiologic measurements of the ambulatory monitoring systema

The results of the PEP also were in favor of the robot-assisted group. A mean PEP value of 131.6 ms was recorded in the robot-assisted group, compared with a mean PEP value of 126.0 ms in the standard group (t = 3.3; p = 0.004).

The average HRA was significantly higher in the standard laparoscopy group. A value of 90.5 beats/min was recorded in the standard laparoscopy group compared with a value of 79.9 beats/min (t = 5.1; p = 0.0001) calculated for the robot-assisted group.

Questionnaires

The SMEQ questionnaire showed a median physical effort in the robot-assisted group of 30 points (range, 10–70), whereas a median of 80 points (range, 50–100) was reported for the standard laparoscopic group (p = 0.001). The LED score for the physical discomfort experienced was 7.4 points (range, 0–25) in the standard laparoscopic group compared with 1.3 points (range, 0–9) in the robot-assisted group (p = 0.001). The median number of physical complaints was 1 (range, 0–8) in the standard group and 0 (range, 0–8) in the robot-assisted group (p = 0.003).

Time-action analysis

In each of the executed tasks of the experiment, the participants performed significantly more repetitions with robot assistance (Table 2). Additionally, fewer failures in task performance were recorded in the robot-assisted group than in the laparoscopic group. This discrepancy was statistically significant (p < 0.001).

Table 2 Results of the action analysisa

Discussion

This study aimed primarily to assess whether robot-assisted surgery can benefit the surgeon in terms of stress reduction and physical comfort. In general, stress can be defined as a specific response by the body to a stimulus that disturbs or interferes with the normal physiologic equilibrium. This physical, mental, or emotional tension of an individual decreases the feeling of being in control of a given situation.

Surgeons control the surgical environment usually by means of mental and physical skills, in cooperation with operating room colleagues and the available equipment. Improving either one of these aspects can increase situational control. In this experiment, the focus was placed on the equipment.

Robot-assisted surgical systems are designed to facilitate manipulation of surgical instruments by increasing freedom of movement and introducing stereoscopic vision. Additionally, physical workload is reduced as the surgeon operates from a comfortable console instead of standing next to the operating table [14]. Ergonomics and user comfort in robot-assisted laparoscopic surgery have not gained much scientific interest but probably are underestimated in an era when more endoscopic procedures are being performed every year, both in basic and complex surgery. A recent study suggests a possible decrease in mental stress with the implementation of robotic techniques, but statistical significance to support this finding has not been established [5].

Our study confirmed that robotic assistance can reduce physical stress significantly. The objective recordings of the ambulatory monitoring system device (MSSD, PEP, HRA) demonstrated robot-assisted surgery to be less stressful than standard laparoscopy. Besides these physical parameters, the mental questionnaires also displayed a significant decrease in mental and physical effort when laparoscopic tasks were performed with the assistance of a robot.

The questionnaires demonstrate that robotic assistance reduced the cognitive workload (p < 0.0001), the amount of physical discomfort (p = 0.001), and the total number of complaints (p = 0.003). The performance of all the tasks in the robotic group was significantly better, with more repetitions and fewer failures.

These results all are highly suggestive of stress reduction. However, some critical remarks must be made. First, physical and mental stress in simulated, experimental conditions is not directly comparable with stress in actual surgical situations. In actual procedures, with teamwork also playing a substantial role, the working environment can be more complex and demanding. The seated position of the participants in the robot-assisted group must be taken into account as well.

Second, with a recording time of 15 min (excluding 7.5 min of practice time), the “operating time” was relatively short. It is likely that more physical discomfort and fatigue arises during actual procedures. This can influence our results [14].

Third, the research group consisted of inexperienced participants without specific surgical skills. Because the effect of surgical skills on the reduction of stress is not known, it is hard to determine whether our research group is comparable with a population of laparoscopic surgeons.

To a certain extent, the aforementioned factors may have affected our results. However, our results clearly indicate that improvement in manipulation and the introduction of a stereoscopic view in a comfortable and ergonomic workspace can contribute to an increased feeling of situational control and a decreased level of physical workload. In conclusion, the implementation of a robotic system for the execution of laparoscopic tasks in an experimental setup enhances performance and reduces cognitive stress levels as well as physical discomfort.

Appendix 1

Subjective Mental Effort Questionnaire (SMEQ) Questionnaire [33]

figure a

Appendix 2

Local Experienced Discomfort (LED) Scale [9]

figure b